www.amitah.eu

 

XenServer Installation

In this chapter we will describe how to install XenServer .

Press ENTER to start the installation  

Choos keymap\Language and click on Ok 

to load additional driver for hard drive \RAID controller press F9 and load or Click OK to proceed next

Click on Accept License agreement to proceed for next screen 

If hardware virtualization (VTX\VTD) enabled on your system which is needed , you will get this warning but you can proceed to complete installation and enable , hardware virtualization from BIOS in next server reboot after installation . 

Installation will remove all existing data from Hard drive ,Click ok to proceed next

Select Installation source and click ok  

Click No for supplemental pack

Its your wish to Verify Installation source or Skip and Click on Ok 

you will get following screen after Verify if all ok and you select Verify Installation source 

Type XenServer root account password and click on Ok 

 Type XenServer IP address , Subnet mask and Gateway and click Ok 

Type XenServer hostname and DNS Server IP and click on Ok

Choos Geographical area and click Ok

Select City and click Ok 

for time i prefer selecting time server (NTP) and click Ok 

Type NTP server address and click on Ok 

Finally you will get a screen saying that all needed info has been collected , now click on Install XenServer to proceed for server installation

wait for Installation to complete ...

Finally you will get a conformation Installation has been completed , Remove XenServer installation media and click Ok and server will be rebooted

After reboot XenServer start booting ..

 

finally you will get this screen when XenServer booted and running now